|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
| The Newbies Arena Are you new to knife making? Here is all the help you will need. |
 |
|
|
Thread Tools | Display Modes |
|
#1
04-25-2018, 04:40 PM
|
|||
|
|||
|
Makers mark - Ink transfer with an iron - Overheating?
Hi again
I just made my first semi successful makers mark! I'm pretty happy right now.  I transfered my logo to the blade with an iron and electro etched the logo afterwards. i'm just worried if i risk overheating the blade? Should i just look for colour change? Any of you have any experience with this DIY makers mark? 
|
|
#2
04-26-2018, 08:22 AM
|
||||
|
||||
|
I never tried it that way. If the iron was less than 300F and if the iron did not need to stay in contact with the blade for very long then there should be no harm to the blade ....
__________________ Your question may already have been answered - try the Search button first!   
|
|
| Tags |
| blade, diy, etch, etched, iron, knife, logo, made, makers, stencil |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Makers Mark | duck26 | The Newbies Arena | 2 | 12-04-2014 11:35 PM |
| Makers mark | JawJacker | The Newbies Arena | 10 | 12-05-2012 07:49 AM |
| Makers Mark: Can this be used? | TikTock | Knife Making Discussions | 2 | 06-29-2005 10:39 AM |
| Makers mark | Drac | Knife Making Discussions | 24 | 04-14-2004 06:03 AM |
| Makers Mark | Steve Milliet | The Newbies Arena | 2 | 01-16-2003 09:38 AM |
Linear Mode
