|
|
Tool Time Let's talk shop. Equipment, Tips & Tricks, Safety issues - Post it here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Duct work/Exhaust fan
I'm finally getting ready to move into a shop. I still run a coal burning forge, and have some questions about exhaust systems. The main problem that I'm running into is that I cannot find a 4-6 inch exhaust fan that can handle the temperatures that are produced. I was going to place the fan close to end of duct work approx 4 feet from opening above the forge, canopy approx 24-36 inche's above fire pit. Does anyone have any tips that I may be able to use in order to make this happen. I do plan on getting a gas forge in the future, but wanted to start off by using coal.
|
Tags |
art, blower, ca, fire, forge, gas forge, handle, heat, home, made, make, metal, photo, problem, shop, show, tips |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat Treat Oven venting? exhaust? etc... | ARCustomKnives | Heat Treating and Metallurgy | 5 | 03-12-2009 02:16 PM |
help with exhaust venting problems... | DragonFang | The Newbies Arena | 2 | 04-23-2004 04:31 PM |
Shop Exhaust ? | idahohiker | Tool Time | 5 | 03-07-2004 10:27 PM |
metal work sheath work available | SVanderkolff | Knife Making Discussions | 0 | 02-15-2004 08:01 PM |
Dust collector/exhaust fan for shop? | AKmik | Tool Time | 8 | 03-05-2003 02:42 PM |