|
|
|
|
|
|
||
|
|
|
|
||
|
|||||||
| Heat Treating and Metallurgy Discussion of heat treatment and metallurgy in knife making. |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-27-2009, 03:39 PM
|
|||
|
|||
|
Favorite recipes...
I have been around awhile but still get curious just how others do things. So, I am asking for your favorite HT recipes for A2, D2 and now CPM154.
Include spring tempers too if you have it. I love A2, find it harder to sell because it is not stainless but 01 always sells well...Go figure. Thanks ahead of time! 
|
|
#2
02-28-2009, 04:23 PM
|
|||
|
|||
|
Well, this did not work out to well. I was just curious about differences in heat treat of steels, particularly A2 and D2. I am using 154 CPM and do have heat treat data on all but still just curious. Some questions just don't work...
|
|
#3
05-09-2009, 11:26 AM
|
|||
|
|||
|
I think I can give you the specs from the huge heat treaters manual. Keep in mind it is for larger cross sections of steel though. PM me if you are interested and I can scan and email what I have. BTW where are you at in TN? I am near Chatt.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
