|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
new member
am new here from south carolina welcome me please
|
#2
|
|||
|
|||
Welcome. Do you have any samples of your work to show us?
Doug __________________ If you're not making mistakes then you're not trying hard enough Last edited by Doug Lester; 12-25-2022 at 01:47 PM. Reason: I hate it when spell check say I misspelled my name |
#3
|
||||
|
||||
Welcome!
You may not be able to post a pic directly yet as a new member though if you have an offsite image link that will work. Use the image format code from this: http://www.knifenetwork.com/forum/mi...bbcode#imgcode __________________ Mike |
#4
|
||||
|
||||
Welcome to the KNF. Looking forward to seeing some of your work.
Where bouts in SC. I spent a good deal of time cruising the Low Country out of Walterboro in the early 70's. Hard working conditions, but hunting and fishing were phenomenal back then. __________________ Carl Rechsteiner, Bladesmith Georgia Custom Knifemakers Guild, Charter Member Knifemakers Guild, voting member Registered Master Artist - GA Council for the Arts C Rex Custom Knives Blade Show Table 6-H |
Tags |
back, fishing, hunting, image, knife, post, show |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Member | Jack Blade | Knife Network Community | 1 | 05-01-2022 04:00 PM |
New member saying Hi | canonman20d | Knife Photography Discussion | 8 | 10-14-2006 03:40 AM |
New member | sdb777 | Factory Knife & Mid-Tech Discussion | 3 | 09-16-2006 11:46 AM |
(nearly) New member | AcridSaint | The North Carolina Custom Knifemakers Guild Forum | 9 | 08-04-2006 10:28 AM |
new member | mete | Heat Treating and Metallurgy | 4 | 09-15-2004 02:32 PM |