View Single Post
  #3  
Old 05-19-2002, 05:20 PM
ansoknives
Guest
 
Posts: n/a



I put front and back together and hold them with Kant-Twist clamps and go to the drillpress



Using a wooddrill with the special point I drill the holes. I don?t use regular drillbits as the graps the kydex and ruins the holes if you are not carefull. Besides the tip make it easy to hit the right spot.



Here are the two parts. Be sure to clean the inside for any dust before putting in the eyelets.



6 eyelets and the right tools. I use the anvil on a cheap vise for this process.



Starting on one eyelet....not finishing the peening but enough to keep the two parts together. The I set one in the oposit corner to align all the holes.



All eyelets set I go to the bandsaw



and saw roughly to shape...do not go too close!!
Reply With Quote